Fig. 475: Identifying Connector, Nuts, And Rear Body Acceleration Sensor G343
Courtesy of VOLKSWAGEN UNITED STATES, INC.
Install nuts - arrows - for body acceleration sensor and tighten to 6 Nm.
Connect harness connector - 1 -.
Install left rear wheel housing liner --> 66 - EXTERIOR EQUIPMENT .
Install wheel and tighten --> 44 - Wheels, Tires, Wheel alignment
Set vehicle on wheels --> Placing vehicle onto lifting platform and onto wheels.
Checking body acceleration signal --> Body acceleration signal of front/rear body acceleration
sensors, checking.
Level Control System Control Module J197 , removing and installing
Removing
If control module is replaced, select function "Replace" of respective control module in "Guided Fault
Finding".
Use Vehicle Diagnosis, Testing and Information System VAS 5051 A.
NOTE:
Points of - arrows - - 3 - of rear body acceleration sensor must point in
direction of travel.
NOTE:
Level Control System Control Module J197 is installed behind glove
compartment on bulkhead.
2008 Audi A6 Quattro
SUSPENSION Suspension, Wheels, Steering
FIXYOURCAR
1:42:01 AM
Page 19
