23
pressed for returning back to the output setup menu.
Output setup >> Delay
This function enables to create a specific delay between the input and the output signal. This
delay can be used for time alignment between different loudspeakers in one configuration.
It is configurable in meters within a range of 0 meter and 12 meter with a resolution of 0.1
meter / step. Adjustments can be done by selecting it and turning the rotary selection dial.
After the required delay is selected, it can be confirmed by pressing the rotary function dial.
Output setup >> Max level
This function will guarantee that the output level adjustable by the fader on the main screen
(which is accessible through user level access) will never exceed a certain value as configured.
This gives protection for non-authorized persons when increasing the volume. It can be
adjusted within a range of 0 dB (no restrictions) and -70 dB.
The screen shows a fader with the configured maximum output level indicated above it.
When selected, the fader including the currently configured maximum output level will turn
green and the level is adjustable by turning the rotary function dial. The fader will slide up
or down and after the desired value has been selected, it can be confirmed by pressing the
rotary function dial.
Output setup >> Standby
When no signal is detected for a corresponding channel, it will be switched automatically to
standby mode. The delay time between the absence of a signal and switching to standby
mode can be selected in this screen. It can be disabled (never) or adjusted within a range
of 1 to 120 minutes. The power consumption will decrease when one or more channels are
switched to standby.
Output setup >> Limiter
The limiter avoids the output exceeding a maximum level.
When configured in 100V mode, the limiter is standard
disabled, allowing the output to slightly exceed the
maximum voltage giving an optimal headroom to peaking
audio signals. When enabling, the output level will be
limited to the maximum level (100V).
When configured in 8 Ohm mode, the limiter is enabled
and cannot be disabled. It will limit on the maximum
allowed output voltage.
Summary of Contents for PMQ240
