11
Rear Panel overview
Rear panel description
AC Power inlet with fuse:
The mains power supply (100-240V AC - 50/60 Hz) has to be applied to this AC power inlet. The connection
is made by an IEC C14 power connector and is fitted with a fuse. When replacing the fuse, make sure that
the value of the replacement fuse matches the value of the original fuse. (T0.5AL/250V)
RS232 Connection:
The RS232 connection can be used to control the system through any external hardware such as home
and industrial automation systems. The pinout and communication settings are described in an earlier
chapter of this user manual. The complete RS232 command instruction set and configuration information
can be downloaded from the AUDAC website.
USB (Update) Connection:
The USB (Update) connection can be used for system firmware updates and/or for connection of the RF
remote control (RMT40) receiver.
Balanced stereo line output:
The balanced stereo line output is implemented using two 3-pin terminal block connectors. The audio
output available on this connector allows it to be fed to any amplifier or pre-amplifier.
F-type antenna connection:
The antenna (input) connection is implemented using an F-type connector whereto the supplied FM
antenna should get connected. Depending of the installation conditions, location and signal strength, it can
be recommended / necessary to extend the antenna using 75
Ω
coaxial cable and connect an external
or outdoor antenna.
