AUBER INSTRUMENTS
WWW.AUBERINS.COM
2013.11
P3/3
Auber Instruments Inc.
5755 North Point Parkway, Suite 99
Alpharetta, GA 30022
www.auberins.com
e-mail: [email protected] Tel: 770-569-8420
Copyright 2007-2015, Auber Instruments All Rights Reserved.
No part of this manual shall be copied, reproduced, or transmitted
in any way without the prior, written consent of Auber Instruments.
Auber Instruments retains the exclusive rights to all information
included in this document.
Figure 3. Install the Sensor
Figure 4. Remove the Sensor
6. How to install the sensor to the unit.
The connector of sensor contains a slot for correct pin connection . It
also has a spring lock to prevent disconnections from accidental
pulling on the cable. To install the to the unit, please align the slot of
the female connector on the sensor to the red mark of the male
connec tor on the unit , then hol d the tail and push the female
connector forward. To remove the connector, please pull the spring
loaded collar of the female connector. Please see the Figure 3 and
Figure 4 below for details.
