INSTALLATION
2. Installation
2.1. Product Inspection
Carefully unpack the amplifier module from the shipping box. If the box or amplifier module is damaged, please notify the
freight company to make a damage claim. If you suspect that there is a problem with the amplifier module that may affect it’s
safe operation, do not install such a suspect Amplifier into the Active MAXNET II Chassis.
2.2. Module Installation into the Active MAXNET
®
II Chassis
Slide the dual-width QMP1000 amplifier module into an open slot in the Active MAXNET II Chassis, one that spans two
single-width module locations beginning with an odd number (indicated by a white marker on the chassis), until the module
drops into its lock position.
The module must be inserted into an odd number slot in order for the amplifier
module to
properly mate to the active chassis
back plane
. If the module is installed properly, the amplifier will make contact with the
24 VDC power bus in the chassis and if there is a MAXNET II Power Supply Module installed in the chassis, and it is plugged
into the respective power source, the module’s PWR (Power) LED indicator will light green. To remove an amplifier module
from the chassis, gently lift the front handle and pull back on the module until it is clear of the chassis guide slot.
Initially, when inserted in the Active MAXNET II chassis, the amplifier will start alarming (the front panel ALM (Alarm) LED
indicator will start flashing red), as there is no RF input signal. The amplifier will stop alarming once RF signal is applied to the
input and all other parameters are within operating conditions.
Figure #3: Front & Rear Panel Pictures
Shown with MCX (left) and F (right) Rear Panel Connectors
MAXNET
®
II – QMP1000 Forward RF Amplifier – Installation & Operation Manual
2-1
CHAPTER 2: INSTALLATION
CHAPTER 1: PRODUCT DESCRIPTION
QMP1000-17GPF
QMP1000-17GP
QMP1000-17GPF
QMP1000-17GP
