7-14 Reset to Initial Setting IV
(Initial Value
：
OFF
）
・
Reset all setting into Initial Value
※
Change ON/OFF by pressing "DAT" switch
※
Short press the "FUN" switch for confirm & Move to Printer Output Setting
※
All setting will be changed into initial value after completing the setting.
List of Initial Value
MARK
ＵＮ
ＨＩ
ＬＯ
OV
ＵＤ
ＤＰ
ＡＦ
ＡＣ
ＭＤ
ＢＰ
ＢＬ
ＩＮ
IV
ＰＯ
*When “TRACK” mode is chosen, it cannot be printed out even though Printer output setting is ON.
*When Printer Output Setting is ON & “PEAK” or “PP” mode is chosen, the letter “PO” is showed at the lower left
part of display.
(This letter “PO” is not shown when “TRACK” mode is chosen)
When you push Reset switch at this moment, the main unit will not be controlled while few seconds until the
display is reset because the main unit is in the mode for searching printer.
Please choose this setting “OFF” when you do not use printer.
Returns to the first setting(7-1. Measurement mode).
7-9
7-10
7-11
7-12
7-13
7-14
7-15
Page to refer
7-1
7-2
7-3
7-4
7-5
7-6
7-7
7-8
7-15.Set printer output
PO
(Initial Setting: OFF
）
・
Set whether to output to the printer or not.
When the printer output setting is ON, the display data can be outputted to the printer by pressing the "RES"
switch.
* Use Mitutoyo's Digimatic Mini Processor DP-1VA as the printer.
* You can switch ON / OFF repeatedly by pressing the "DAT" switch.
* Short press the "FUN" switch to confirm the setting.
Initial Setting
ＴＲＡＣＫ
N
･
m or N
･
cm
0
0
120
10
ＯＦＦ
ＯＮ
ＯＦＦ
ＯＮ
ＯＮ
ＯＦＦ
ＯＦＦ
ＯＦＦ
FUNCTION NAME
Set measurement mode
Change measuring unit
Set comparator HI
Set comparator LO
Set overload
OV
Set screen update rate UD
Set flipping screen DP
Set auto power off AF
Set auto reset AC
Set printer output PO
or
Set the minimum digit display MD
Set buzzer BP
Set backlight BL
Set polarity IN
Reset to Initial Setting IV
ＯＦＦ
The display changes every
time the "DAT" switch is
pressed.
The display changes every
time the "DAT" switch is
pressed.
