ATTO Technology iPBridge 2600, Installation And Operation Manual

Page: 44 / 50

xiii
ATTO Technology Inc. iPBridge Installation and Operation Manual
SCSIPortReset
Resets the SCSI bus.
SCSIPortReset [sb]
SCSIPortResetOnStartup
Controls whether the SCSI bus is reset each time the
iPBridge is powered up.
Default: enabled
set SCSIPortResetOnStartup [sb] [enabled | disabled]
get SCSIPortResetOnStartup [sb]
SCSIPortSyncTransfer
Controls the iPBridge attempts to negotiate synchronous
SCSI transfers with devices on the specified bus.
Default: enabled
set SCSIPortSyncTransfer [sb] [enabled | disabled]
get SCSIPortSyncTransfer [sb]
SCSIPortTermination
Configures the SCSI internal termination of the specified
SCSI port. Enabling termination allows the iPBridge to
act as a terminator at the end of a SCSI chain.
Default: enabled
set SCSIPortTermination [sb] [enabled | disabled]
get SCSIPortTermination [sb]
SCSIPortWideTransfer
Controls the iPBridge attempts to negotiate wide SCSI
transfers with devices on the specified bus.
Default: enabled
set SCSIPortWideTransfer [sb] [enabled | disabled]
get SCSIPortWideTransfer [sb]
SCSITargetLUNs
Controls the maximum number of SCSI LUNs per target
the iPBridge queries during a SCSI bus scan.
Default: 8
set SCSITargetLUNs [sb] [8 | 32]
get SCSITargetLUNs [sb]
SCSITargets
Lists the physical devices that are connected and running
on the specified SCSI port.
SCSITargets [sb]
SerialNumber
Displays the serial number of the iPBridge. The serial
number is a 13 character field. The first seven
alphanumeric characters are an abbreviation
representing the product name. The remaining six digits
are the individual iPBridge number.
get SerialNumber
SerialPortBaudRate
Configures the baud rate for the iPBridge RS-232 serial
port. The number of data bits per character is fixed at 8
with no parity.
Default: 115200
set SerialPortBaudRate [ 9600 | 19200 | 38400 | 57600 |
115200]
SaveConfiguration Restart command required
get SerialPortBaudRate
SerialPortEcho
Controls if the iPBridge echoes characters on its RS-232
port. When enabled, all non-control character keyboard
input is output to the display.
Default: enabled
set SerialPortEcho [enabled | disabled]
get SerialPortEcho
SNMP
Controls whether or not SNMP functions on the iPBridge.
Default: enabled
set SNMP [enabled | disabled]
get SNMP
SNMPDumpMIB
Displays the contents of the ATTO iPBridge private
SNMP MIB to the current CLI session. For further
assistance with SNMP, consult your network
administrator.
SNMPDumpMIB
SNMPExtendedTraps
Regulates Extended (i.e., Device Transition and Device
Error) SNMP trap functionality.
Default: disabled
set SNMPExtendedTraps [enabled | disabled]
get SNMPExtendedTraps