31
ATTO Technology FibreBridge 4500 Installation and Operation Manual
4.1.5 Fibre Channel configuration commands
The Fibre Channel ports are configured with default settings but may be customized using the CLI
commands in this section.
BootFibreDelay
Initialization of the Fibre Channel port is delayed by 0, 15 or 30 seconds to allow a connected Fibre switch to fully initialize before
the FibreBridge announces its presence.
Limits: 0, 15 or 30 seconds
Default: 0 (no delay)
Action:
set BootFibreDelay [0|15|30]
Information:
get BootFibreDelay
SaveConfiguration
BootScan
Provides dynamic mapping of SCSI devices to the Fibre port/LUN combination via a SCSI bus scan at boot time. All devices
discovered during the bus scans will be assigned to a Fibre port, Fibre LUN combination until the next reset/power cycle. This
dynamic mapping will replace the current, static mapping of the FibreBridge.
Limits: enabled, disabled
Default: disabled
Action: set
BootScan [enabled|disabled]
Information:
get BootScan
SaveConfiguration
BootScanPorts
For legacy applications, selects/displays the ports to be used for a boot scan.
Action:
set BootScanPorts [fp | all | auto]
Information:
get BootScanPorts
SaveConfiguration
DispFcPortDB
Displays the contents of the specified FC port’s internal port database which contains Fibre Channel addressing information for
each FC target device visible to the FibreBridge.
Action:
none
Information:
DispFcPortDB <fp>
Returns: Node name, 24-bit port ID, 8-bit internal loop ID of each FC
device
FcAck0
Specifies whether ACK0 or ACK1 will be returned in response to a Class 2 FC data frame or sequence. Enable sends ACK0 at the
end of a sequence. Disable returns an ACK1 frame for each data frame.
Limits: enabled, disabled
Default: disabled
Actions:
set FcAck0 [enabled |disabled]
Information:
get FcAck0
SaveConfiguration
FcClass2
Specifies whether the FibreBridge will support Fibre Channel Class 2 (multiplexed) service.
Limits: enabled, disabled
Default: disabled (use Class 3 service)
Actions:
set FcClass2 [enabled |disabled]
Information:
get FcClass2
SaveConfiguration
FcConnMode
Controls/reports the connection mode the FibreBridge uses when communication across a Fibre Channel network, either to an
arbitrated loop (FC-AL) when you select
loop
mode, or point-to-point when you choose
ptp.
Limits: applies to all Fibre Channel ports
Default: loop
Actions:
set FcConnMode [loop | ptp]
Information:
get FcConnMode
SaveConfiguration
