27
ATTO Technology FibreBridge 4500 Installation and Operation Manual
4.1.3 Maintenance commands
The CLI commands outlined in this chapter may be used to get information or perform functions which
are used in a variety of situations with the ATTO FibreBridge.
FirmwareRestart
Causes the FibreBridge to reboot, then re-initialize its firmware.
Actions:
FirmwareRestart
Information:
none
FixedLengthReqSense
If enabled, forces the FibreBridge to pad the number of bytes of autosense data returned as a result of a CHECK CONDITION to
a
mod 4
length.
Default: disabled
Action:
set FixedLengthReqSense [enabled|disabled]
Information:
get FixedLengthReqSense
IsReserved
Displays the reservation status of the current FibreBridge session/interface. If set, the configuration image is being modified by another
FibreBridge services session: set commands are temporarily unavailable but information commands are available. Executing a
SaveConfiguration, RestoreConfiguration or FirmwareRestart RELEASES the FibreBridge so that other services users may access it.
Limits: When FibreBridge services interface is RESERVED, set commands from other users are unavailable.
At least one interface must always have access to the FibreBridge.
Action:
none
Information:
IsReserved
Return: [NOT set | set]
MaxEnclTempAlrm
Sets/displays the maximum enclosure temperature alarm of the unit in degrees Celsius. If the temperature of the FibreBridge rises above the
maximum MaxEnclTempAlrm, thermal control event handling occurs.
Limits: valid entries are between 0 and 70 degrees and
above the current minimum enclosure temperature alarm
Default: 70
o
C
Actions:
set MaxEnclTempAlrm [0-70]
Information:
get MaxEnclTempAlrm
SaveConfiguration
MinEnclTempAlrm
Sets/displays the minimum enclosure temperature alarm of the unit in degrees Celsius. If the temperature of the FibreBridge falls below the
minimum MinEnclTempAlrm, thermal control event handling occurs.
Limits: valid entries are between 0and 70 degrees and
below the current maximum enclosure temperature alarm
Default: 0
o
C
Actions:
set MinEnclTempAlrm [0-70]
Information:
get MinEnclTempAlrm
SaveConfiguration
Reserve
Reservation of the FibreBridge is implicit: once the configuration image is changed by any user of services, the FibreBridge becomes RESERVED.
Executing a SaveConfiguration, RestoreConfiguration or FcRestart RELEASES the FibreBridge so that other services users may access it.
Limits: When FibreBridge services interface is RESERVED, set commands from other users are unavailable.
At least one interface must always have access to the FibreBridge.
Action:
Reserve
Information:
none
Return: [enabled | disabled]
RestoreConfiguration
Restores configuration to either the default configuration or the configuration last saved into non-volatile memory. The saved option will undo
any changes made since the last save.
Actions:
RestoreConfiguration [Default | Saved]
Information:
none
ScsiPortReset
Resets the specified SCSI bus.
Actions:
ScsiPortReset [sb]
Information:
none
