xii
Route
Assigns a Fibre Channel address to a target destination
device. If you try to map a new SCSI BTL to the same FC
LUN, the new BTL overwrites the previous map. Using
the delete identifier removes the map from its table. If
VerboseMode
has been enabled, overwriting an existing
map requires secondary confirmation.
Route FC [fp] [lun] [SCSI <sb st sl> | Bridge | Delete ]
RouteDisplay
Displays a list of Fibre Channel to SCSI address
mappings on the FibreBridge.
RouteDisplay FC <fp> <lun>
SaveConfiguration
Many commands require a
SaveConfiguration
command to be executed as indicated by the return
Ready. *
. When you invoke a
SaveConfiguration
command, the current configuration is permanently saved
in the FibreBridge and the new configuration becomes
the active configuration. If a firmware restart is required
to make the requested change permanent, you are asked
to confirm the restart. You can override this request by
indicating the override value on the command line. You
may make several changes through commands before
implementing the restart, but once you have restarted the
FibreBridge, all the command changes created before the
restart and save are implemented. If you select the restart
option, the FibreBridge executes its complete start up
cycle.
SaveConfiguration <Restart | NoRestart>
SCSIDomainValidation
Runs domain validation tests on the SCSI system which
may detect problems with SCSI cables, termination or
damaged transceivers. Disable
VirtualDriveResponse
before running the test If tape drives are attached to the
FibreBridge, ensure they are loaded with media: media is
not overwritten with this test. Reboot the FibreBridge
after running this test.
SCSIDomainValidation
SCSIInitID
Specifies or reports the SCSI initiator ID on the specified
SCSI port as found in NVRAM. All maps coinciding with
the user-specified SCSIInitID are destroyed after the
command completes.
Default: 7
set SCSIInitID [sb [0-15] ]
get SCSIInitID
SCSIPortBusSpeed
Controls the transfer rate at which the FibreBridge
negotiates with its SCSI devices. Valid options are Fast
SCSI, Ultra SCSI, Ultra 2 SCSI, Ultra160 SCSI and
Ultra320 SCSI.
Default: ultra320
set SCSIPortBusSpeed [sb [ fast | ultra | ultra2 | ultra160
| ultra320]
Requires a SaveConfiguration command
get SCSIPortBusSpeed [sb]
SCSIPortList
Returns a list of available SCSI ports and their current
status. Valid status values are
OK
and
Failed
SCSIPortList
SCSIPortReset
Resets the specified SCSI bus.
SCSIPortReset [sb]
SCSIPortResetOnStartup
Specifies if the SCSI port should be reset on power-up.
Default: enabled
set SCSIPortResetOnStartup [sb [enabled | disabled] ]
Requires a SaveConfiguration command
get SCSIPortResetOnStartup [sb]
SCSIPortSyncTransfer
Specifies whether synchronous SCSI transfers should be
negotiated with devices on the specified SCSI port.
Default: enabled
set SCSIPortSyncTransfer [sb ] [enabled | disabled]
Requires a SaveConfiguration command
get SCSIPortSyncTransfer [sb]
