ATTO Technology FastStream NDMP 4600, Installation And Operation Manual

Page: 49 / 58

42
Interfaces: CLI
5.1.10 Mapping commands
You may map devices via the web-based server or through the management or serial ports. Refer to
Alternative interface options on page 19
Note
The recommended management tool for the
FastStream NDMP 4600 is ATTO
ExpressNAV.
AutoMap
Automatically assigns NDMP LUNs to a set of target
destination devices visible to the FastStream NDMP
4600. Automap with no arguments maps all drives to the
default target. By specifying a target name, Automap
maps all devices to that target. By specifying “*”,
automap maps each device to its own auto-named target.
AutoMap <default |Target Name *>
AutoMapOnBoot
Controls automatic device detection and mapping
(automap) at FastStream NDMP 4600 startup.
Default: enabled
set AutoMapOnBoot [enabled | disabled]
Requires a SaveConfiguration command
get AutoMapOnBoot
DeleteAllMaps
Removes all mapped devices from the map table. If you do
not create other mapping before the next firmware
restart, the default mapping is used.
DeleteAllMaps
Route
Assigns a host protocol address to a target destination
device.
Route NDMP [default | target name] [lun] [SCSI <bb tt ll>|
Bridge | Delete
]
RouteDisplay
Displays a combined list of host protocol addresses to
target destination device mappings.
RouteDisplay NDMP [default <lun>|Target Name <lun>]