10
as industrial waste in accordance with the local laws
and regulations.
●
Treat flushing water through pH adjustment,
condensation/sedimentation, activated sludge
process, activated carbon adsorption, etc., and
discharge it in accordance with the regulations of
your local municipal bylaw.
●
Residual dross will remain in an emptied container:
be careful when handling an empty container.
(7) Others
●
When Cutting Oil is poured into another container
for use, post chemical and label information at the
site where it is kept. At the same time, keep the
Operation Manual handy so that it can be referred to
whenever necessary.
●
For further details, contact us for product safety data
sheet.
●
All the information and descriptions that have been
provided are based on the currently available
documents and information, which may be revised
upon our new recognition and/or discovery.
●
The precautions provided apply to regular handling.
If special handling method is used, take safety
measures that are suitable for your applications and
usage.
●
The information contained herein is for your
reference purpose only, to which we make no
warranty of any kind and for which we shall not be
held responsible.
Preparation of Cutting Oil
(1-1) Use our genuine-product Cutting Oil (blue).
If other Cutting Oil is used, the cutting
performance and service life of cutter would be
decreased.
(1-2) Use tap water to dilute Cutting Oil by 8- to
10-fold. Do not use well water.
(1-3) Cutting oil should be supplied to the drill using
the Jet Oiler or the Tank, both of which are sold
separately.
5-5. Position Change of Rod Handles
●
Rod Handles can be positioned either on the right
or left side of the machine, by changing the Pinion
Shaft insert direction as follows;
(1) Unscrew Hex. Soc. Head Cap Screw 8x20
using Hex. Socket Screw Key 6 included in the
accessories.
(2) Pull out the Pinion Shaft Assy with Rod Handles
as shown in the sketches in Fig. 14.
Pinion Shaft
Rod Handle
Hex. Nut Type1 M8
Hex. Soc. Head Cap Screw 8X20
Washer 30X8.2X3.2
Fig. 14
Always keep the pinion teeth clean and covered
with grease.
(3) Insert the Pinion Shaft Assy from the other side
of the shaft hole, and put the Screw back.
5-6. Connecting the Power Supply Plug to Power
Source
●
Before connecting the power supply plug to power
source, turn off the switch.
Always use the correct voltage for power source.
6 MACHINE OPERATION
WARNING
●
Always Wear Safety Glasses.
●
Always Wear Hearing Protection.
●
Wear respiratory protective equipment.
●
Never touch the mounted cutter and the rotating
parts of the machine such as the Spindle Arbor
after the power cable is connected to power
source.
CAUTION
●
Do not use hard material such as a screwdriver,
to operate the Motor Switch. This may damage
the panel and switch, which would lead to
machine failure.
6-1. Start and Stop
●
The Drill Motor will not rotate unless a Magnet
is turned on in operating the Motor Switch.
(1) Start
●
Magnet ON
(Fig.15)
Turning the Magnet Switch ON illuminates the
switch lamp and energizes magnetic power.
WOJ-3200.indd 10
10.11.12 11:13:25 PM
