Atosa EBF-03, Instruction Manual

Page: 7 / 20

5
4.2 INITIAL CLEANING
Before use all parts of the cabinet should be cleaned,
For the walls and all the internal parts use an
antibacterial detergent. For the plastic parts use a
moistened cloth.Dry with a soft clean cloth.use
little or no water.
Do not use harsh or abrasive solvents or detergents
During cleaning do not approach bare-handed those
parts which could cut (evaporator, condenser, etc.) and always use protective gloves.
4.3 Electrical connection
Check that the supply conforms to the requirements
listed on the factory label and that it is provided
with a fall-safe protection or automatic circuit
breaker with an efficient earth connection.
Should there not be an electrical safety
feature have this introduced by a qualified person.
by means of a omnipolar switch as indicated
in the safety regulations with a means of a
omnipolar switch as indicated in the safety
regulations with a minimum clearance of the
contacts of 3 mm. where the cabinet
has to be installed at some distance from
the electrical source.ensure that the conforms
to the local regulations. Cabinet supplled
with integral condensing units are provided
with an appropriate plug fitted with a neutral
and earth; the supply cable must be well
stretched (avoid coilling and superimposition).
it must not be exposed to the possibility of damage
by third parties. it should not be in contact with
liquids, water or heat sources. in the event
of damage it must be replaced by qualified
personnel. Always avoid the use of reducers or
adapters.
AC220-240V
Outlet Only
Grounding Terminal