Atosa ATO-4B-F, Operating Instructions Manual, Page: 16 / 28

- 15 -
otherwise, may cause hazards, and the manufacturer has the right not to
provide warranty service;
Steel cutting producers used to manufacture with sharp edges. The
manufacturer has dealt with these sharp edges during production, however,
we insist the operator take care when in contact with this piece of
equipment;
Always keep hands, hair and clothing away from heating source.
Wait the unit cools down before cleaning. Because the unit is too hot to
handle after using.
8. Operating Instructions
Before operating, make sure to place the unit horizontally by adjusting
bottom adjustable legs, and place the catch tray properly.
To ensure that the air flow in the bottom of the equipment.
Do not use fan or air-conditioning blowing at the flame, in order to
avoid extinguishing flame and cause safety accidents;
Must be installed the matched exhaust hood according to the local
regulations above the equipment.
To ensure that the air in the kitchen is kept in circulation.
The pilot light has been set at the factory. Each burner has a pilot light.
8.1 Lighting the fire （ hot plates ）
①、 Align the control valve knob on the "O" position (Fig.2), so that the valve is
closed.
②、 And then axial press the front air valve knob, left 30 degrees, to the fire
position (Fig.3).
③、 At the fire position, completely press the knob, meanwhile light the fire
by pilot with another hand. Keep pressing the knob about 10-15 seconds,
and observe stability of fire.
④、 If the fire is not lit, please repeat the above steps until the fire is ignited.
Tip ： The pilot light may not be lighted immediately, for existing gas in