DM doc. V.1_Z2813
|
7
PKB-60 Programming Software
Chapter 2. Programming Software Introduction
1.
This programming tool works only under USB interface of PKB-60
POS keyboard. Please make sure if your USB jack is well connected
to PC’s USB port, please refer
(
Figure 1.0.
)
2.
Please disable power saving in your system while using
programming tool. Or close programming tool if you will leave for a
while.
2.1 The Main Interface of Programming Software
2.1.1 Toolbar
New
: Create a new programming table
Open
: Open the saved programming table document. (dat document format)
Save
: Save the programming table, the format is dat
Read
: Reade the programming table from the keyboard
Write
: Write the programming able to the keyboard
(Note! Before reading the key
value from keyboard, please do not press this button.)
Card
: Set some parameter about the magnetic stripe card reader
Help
: Open the user manual
Exit
: Exit the software
Figure 2.1
Figure 2.1.1