ATO EQ-Link system, Operation Manual

Page: 20 / 29

Operation Manual
Page 14 ATO Aviation Inc.
6. INSTALLATION
6.1. Installation EQ-Link
The EQ-Link system is supplied with a standard aviation cables and
connectors (jacks) to suit standard aviation connections. The EQ-Link system
will automatically power ON when the aircraft communications system is
turned on, and will automatically power off when the communications is
switched off. A permanent optional charge cable can be connected for peace
of mind to ensure the EQ equipment is always charged.
When you aircraft communications is switched off the EQ-Link and EQ1
Headset will automatically power OFF.
Simply connect your EQ-Link into where your normal headset would be
connected. The EQ-Link is supplied with Velcro for simple mounting and a
cable clip for additional support. For additional performance operation when
multiple EQ-Link modules are used on one aircraft simply set extra units to
SLAVE mode. In this mode all the units will operate as one and not interfere
with each other, their must be at lease one master in all systems.
Slave mode can be entered by pressing and holding the STATUS button for 4
seconds, the LED lights will then change every 2 seconds from Master to
Slave and announce this in the headset. When on the desired mode, just
release the button.
NOTE: A typical aircraft can only have one master and up to 5 slaves in the
single system for peak performance, in the case of more units please contact
your supplier for additional information on your options.
YOUR INSTALLATION IS NOW COMPLETE…………