ato form Liftolet, User Manual

Page: 15 / 32

Page 15/32 (07/21)
Assembly and adjustment
Mounting without use of the base plate:
• After the conditions are given for
mounting, place the Liftolet over the WC
and position correctly.
Attention:
When positioning the Liftolet, do not
take hold of the cable channel (6),
carrier plate (4) or support handles (7),
however only hold on to the lifting
columns.
• Lower the carrier plate of the WC onto
the WC bowl by loosening the 3 screws
located underneath the toilet seat on
either side.
• Fasten the 3 screws on either side again
once the carrier plate rests on the WC.
Attention:
Hold the carrier plate when loosening
the screws to prevent it from falling
onto the WC.
• It is recommended to raise the Liftolet
once before marking the bore holes onto
the floor to ensure the Liftolet does not
brush against anything, also when the lid
is open.
Attention:
Ensure the Liftolet does not fall over
whilst rising.
• Only after this test mark the holes on the
floor for the mounting flanges and carry
out the base fixing. When tightening the
floor mounting screws, ensure the Liftolet
is not braced by eventual floor uneven-
ness. In such a case the mounting flanges
should be adequately supported.
• Please note that the structural rules are
to be observed. It must be ensured that
the floor condition can withstand the load
and no cables in the ground are dam-
aged.