3
OPERATING
mounTIng
The ATN Night Vision Riflescopes Mounting System allows to change the position of the riflescope
flexibly on the weapon in relation to a shooter in combination with the fixed positions already avail-
able on the weaver rail. For this purpose in the base of the mounting bracket there is a rail with a
fixing projection. There are three grooves in the mounting bracket for mounting this rail. Besides it is
possible to change the position of the riflescope additionally by 1/3 of inch. For doing this one needs
to about-face the rail.
To change the position of the riflescope on the weaver rail
additionally follow the steps mentioned below:
1. Unscrew the two screws, which attach the rail to the
mounting bracket.
2. Take the rail out of the groove.
3. About-face the rail in case of necessity.
4. Place the rail into another groove.
5. Fix the rail with the two screws.
Note :
If the rail is not taken out easily, screw up tight one of screws into the threaded aperture
in the middle of a fixing projection of the rail. Continue rotation of the screw. Thus the screw will
push out a rail from a groove.
The scope can be mounted onto the Weaver rail using
optional A.R.M.S.#19 ACOG mount.
1. Remove the standard ATN Mounting System from the
scope. Unscrew the two mounting screws, which attach
the ATN Mounting System to the body of the scope.
2. Mount the A.R.M.S.#19 mount onto the scope with
two mounting screws.
3. Slightly loosen the fixing levers of mount.
4. Place the scope on the weaver rail of the firearm.
5. Tighten the fixing levers of A.R.M.S. mount.
conTRol
To turn the device on, rotate the Operation Switch from the OFF position to
the desired operation mode.
Operation Switch has following positions/modes:
OFF - the device is off;
ON – the device is on;
STB - the device can be used with the Remote Control.
REmoTE conTRol
Attach the Remote Control cable to connector on the bottom of the
body of device. Place the Remote Control on the weapon, suiting your
shooting style best and grip. Fix the Remote Control in this position
with a montage strap.
To turn the scope on push the button of remote control. Keep pressed
button when observing scene. The scope is turned off immediately
after releasing remote control button.
focusIng
To focus the scope you need to adjust the diopter first. Simply turn the
diopter clockwise until it stops. Then concentrate on any object and slowly
turn the diopter back counter clockwise until the grain in the image is
sharp.
You scope has ability to focus either long range or short.
Focus the front lens by rotating the knob until the image and the grain are
Focus adjustment knob
Mounting bracket
Grooves
Rail with a fixing
projection
Screws Mounting screws
Mounting
screws
A.R.M.S.#19
mount
