10
6.0 Repairs and servicing
Maintenance, repairs and period tests may only be carried out by persons who have the appropriate technical knowledge and
are familiar with the product. To carry out these measures the person must have the necessary test devices and original spare
parts.
ATMOS recommends: Work should be carried out by an authorized ATMOS service partner. This ensures that repairs and
testing are carried out professionally, original spare parts are used and warranty claims remain unaffected.
•
Please comply with the country-specific guidelines regarding regular testing especially for the electrical safety. ATMOS
recommends a test every 24 months.
• Make sure prior to every application of the equipment that it is technically safe and in proper condition. Damaged cables must
be replaced immediately!
• The light source ATMOS
®
LS 21 LED is low-maintenance. The instructions and regulations for the respective field of
application should be observed.
• Repair work may be carried out only by expert personnel authorised by ATMOS. At this pay attention to chapter 2.0 „For your
safety“.
• There are no warranty claims whatsoever on defects or malfunctions which arise from the use of third party accessories or
consumables.
6.1 Sending in the device
• Remove and properly dispose of consumables.
• Clean and disinfect the product and accessories according to the operating instructions.
• Place used accessories with the product.
• Fill in the form QD 434 „Delivery complaint / return shipment“ and the respective
decontamination certificate
.
)
This form is enclosed to each delivery and can be found at www.atmosmed.com.
• The device must be well padded and packed in suitable packaging.
• Place the form QD 434 „Delivery complaint / return shipment“ and the respective
decontamination certificate
in an
envelope.
•
Affix the envelope to the outside of the package.
• Send the product to ATMOS or to your dealer.
The ATMOS
®
LS 21 LED was subjected to a thorough quality control in the factory. If however any problems should occur, you
can possibly eliminate these personally, if observing the following notes.
Error indication
Cause of error
Troubleshooting
No light
•
LED battery is flat
• Cable is not connected properly
• Cable is defective
• Charge LED battery
• Connect cable
• New cable
LED battery cannot be charged
• LED battery is defective
• Charging power pack is defective
• New LED battery is required
• New charging power pack is
required
7.0 Troubleshooting
