Getting Started
2-2
STK512 User Guide
5170C–AVR–10/09
1.
Carefully remove any ICs in the green “SCKT3200A2” socket.
2.
Insert the furnished ATMega88 into the “SCKT3200A2” socket.
Note:
The orientation of the red stripe in the cable is not critical in the following steps as long as pin 1 is con-
nected to pin 1.
3.
Using a 6-pin jumper cable supplied with the STK500;
connect the two male headers “ISP6PIN” and “SPROG2”.
4.
Using a 10-pin jumper cable supplied with the STK500;
connect the two male headers “PORTC” and “LEDS”.
5.
Using a 10-pin jumper cable supplied with the STK500;
connect the two male headers “PORTD” and “SWITCHES”.
6.
Place jumpers on the following headers as shown in
– VTARGET
– AREF
– RESET
– XTAL1
– OSCEL (a 3-pin header. Place a jumper next to the “1” printed on the board).
Figure 2-2.
Detail of Jumper Placement on the STK500
