STK200 Starter Kit
5-1
Section 5
Installing the Software
5.1
Windows 95
To install the software, insert the supplied disk or CD-rom in your computer and perform
the following steps:
1.
Click on your “Start” button.
2.
Select “Settings”.
3.
Select “Control Panel”.
4.
Choose “Add/Remove Programs”.
5.
Click the “Install” button.
6.
Follow on-screen prompts.
The software will then be installed onto your computer and an icon will be added to your
start menu.
5.2
Windows 3.1
Choose “RUN” from Program Manager and enter “A:\SETUP.EXE” as the filename.
Press the “OK” button and the software installation program will begin.
The software will then be installed onto your computer and an icon and Program Group
will be added to Program Manager.
Note:
On some PCs, especially laptops, programming problems may occur if the Bios
Parallel Port settings are set to EPP Version 1.7. If programming problems do
happen, make sure that the Parallel Port settings in your BIOS are set to EPP
V1.9 not V1.7.
In the unlikely event that you have any problems installing the software or suspect that
you have faulty media, please contact the Atmel Starter Kit hotline:
Hotline Number:
(44) 1970 621 049
Fax Number:
(44) 1970 621 040
E-mail:
Summary of Contents for STK200
