Atmel QT600 Quick Start Guide
Connect the kit modules
1
QTouch8 with ATtiny88
Choose the QTouch8 and the ATtiny88:
1.1
Open the Atmel AVR Studio
®
1.2
Select Open in Project Wizard window
1.3
Select
C:\Program Files\Atmel\Atmel_QTouch_Libaries_4.3\Generic_QTouch_Libraries\AVR_Tiny_Mega_
XMega\QTouch\ example_projects\QT600_ATtiny88_gnu_qt8
1.4
Connect the 6-conductor ribbon cable from the ISP header on the ATtiny88 board to the ISP/PDI header on the
QT600 Interface board
1.5
Connect the flex cable from the QTouch8 board to the ATtiny88 board
1.6
Connect the USB cable between your PC and the QT600 Interface board (Three LEDs should light up—then hold
the button down for five seconds until the ‘Touch Data’ LED turns off)
1.7
In AVR Studio, click the ‘
Con
’ button on the top toolbar
1.8
Select QT600 as the Platform and USB as the Port, and then click
connect
2
VTG Jumper
Figure 2 – Close-up of the Atmel QT600 interface board and location of the VTG
Note: On the main QT600 control board, make sure the jumper is in place on the VTG. The board should be configured as above:
Touch Solutions
Atmel QT600 Quick Start Guide
Affix the rubber stoppers to
QTouch8 (4), QTouch16 (4),
QMatrix 8x8 (6), and the QT600
main controller board (4) leaving
two spares.
