24
6174B–ATARM–07-Nov-05
AT91FR40162S Preliminary
10.5
Byte Write or Byte Select Access
Each chip select with a 16-bit data bus can operate with one of two different types of write
access:
• Byte Write Access supports two byte write and a single read signal.
• Byte Select Access selects upper and/or lower byte with two byte select lines, and separate
read and write signals.
This option is controlled by the BAT field in the EBI_CSR (Chip Select Register) for the corre-
sponding chip select.
Byte Write Access is used to connect 2 x 8-bit devices as a 16-bit memory page.
• The signal A0/NLB is not used.
• The signal NWR1/NUB is used as NWR1 and enables upper byte writes.
• The signal NWR0/NWE is used as NWR0 and enables lower byte writes.
• The signal NRD/NOE is used as NRD and enables half-word and byte reads.
shows how to connect two 512K x 8-bit devices in parallel on NCS2.
Figure 10-6. Memory Connection for 2 x 8-bit Data Busses
Byte Select Access is used to connect 16-bit devices in a memory page.
• The signal A0/NLB is used as NLB and enables the lower byte for both read and write
operations.
• The signal NWR1/NUB is used as NUB and enables the upper byte for both read and write
operations.
• The signal NWR0/NWE is used as NWE and enables writing for byte or half word.
• The signal NRD/NOE is used as NOE and enables reading for byte or half word.
EBI
D0 - D7
D8 - D15
A1 - A19
A0
NWR0
NRD
NCS2
D0 - D7
A0 - A18
Write Enable
Read Enable
Memory Enable
NWR1
D8 - D15
A0 - A18
Write Enable
Read Enable
Memory Enable
