AT-OMNI-232
10
Installation
1.
Connect captive screw audio connectors to LINE/MIC IN ports from audio sources (
e.g.
MICs).
2. Connect an Ethernet cable to the
ETHERNET
port.
3.
Connect captive screw connectors from LINE OUT ports to audio players/distribution devices
(
e.g.
AT-PA100-G2).
4.
Log onto a local network computer and use the Dante Controller and AMS software to adjust device and audio
for Dante Controller instructions.
Audio Connector
LINE/MIC IN
-
+
MIC/LINE
LINE
Balanced
Unbalanced
Connect
dynamic, self-powered, wireless, or phantom powered microphones, receivers (or other audio sources) with
line level outputs using the included captive screw connectors. Either balanced or unbalanced connections may be
used.
1. Use wire strippers to remove a portion of the cable jacket.
2.
Remove at least 3/16” (5 mm) from the insulation of each wire.
3.
Insert the wires into the correct terminal on the included Phoenix connector, as shown below.
4. Tighten the screws to secure the wires. Do not use high-torque devices as this may damage the screws and/or
connector block.
NOTE:
Phantom power is set to off by default, to ensure MICs without phantom power are not damaged
NOTE:
Use of a jumper is needed between negative and ground ports when using an unbalanced
connection
NOTE:
Connect to a PoE enabled switch, if one is not available, a power supply (AT-PS-24250-L) is
purchasable through Atlona for local power.
NOTE:
Phantom power must be turned on within AMS
NOTE:
To ensure stable connection, disable 802.3 Energy Efficient Ethernet (EEE) on connected Ethernet
switches.
Connection Instructions
+
Positive
Ground
+
Positive
Ground
Negative
-