AT-OME-ST31
33
Display Auto Power Off
Sends the command to power-off the display when an A/V signal is no longer present. Click the toggle to enable or
disable this feature.
Lamp cool down timer
Sets the cool-down interval, in seconds, before the projector can be powered-off. During this time interval, the
projector will not accept any “power on” or “power off” commands until the last “power off” command has been
processed and the projector lamp has completed the cool-down cycle. Range: 0 to 300.
Auto Power Off
Timer
Click this drop-down list to set the time interval, in seconds, between when the loss of A/V signal is detected and
when the “Display Off” command is sent to the display. Range: 0 to 300. The default value is 15 seconds.
Power on delay timer
Sets the time interval, in seconds, between when the display is powered on and when the
DISPLAY
button, on the
front panel, will be locked. Range: 0 to 300.
Control Type
Sets the control method for sending commands. The following options are available: RS-232, IP, CEC.
Feedback Verify
Sets the feedback verification state. Click the toggle to enable or disable this feature. The following options are
available.
The Web GUI
Setting
Description
RS-232
RS-232 is used to send commands.
IP
Commands are sent over IP.
CEC
Uses CEC to send commands.
IP Mode
Click this drop-down list to select the control method for volume and muting.
IP Address
Enter the IP address of the display in this field.
Port
Enter the listening port of the device in this field.
Username
Enter the username for login.
Password
Enter the password for login.
Setting
Description
Non-login
Does not require a username and password when using TCP/IP to control the
display.
RS-232
Requires a username and password to control the display through TCP/IP.
