3
Installation Guide
AT-OME-EX-KIT
LAN
HDBaseT IN
DC 48V
AT-OME-EX-RX
HDMI OUT
RX
TX
TX
RS-232 IR
LAN
FW
HOST
OMEGA
TM
DEVICE
PWR
LINK
AT-OME-EX-RX
FW
PWR
LINK
OMEGA
TM
DEVICE
HDMI IN
AT-OME-EX-TX
HDBaseT OUT
RX
RX
TX
RS-232 IR
LAN
HDBaseT IN
DC 48V
AT-OME-EX-RX
HDMI OUT
RX
TX
TX
RS-232 IR
LAN
FW
HOST
OMEGA
TM
DEVICE
PWR
LINK
AT-OME-EX-RX
FW
PWR
LINK
OMEGA
TM
DEVICE
HDMI IN
AT-OME-EX-TX
HDBaseT OUT
RX
RX
TX
RS-232 IR
1
PWR / LINK
The
PWR
LED indicator will glow green when the AT-OME-EX-RX is powered. The
LINK
LED indicator glows yellow when a solid link is established between the transmitter and
receiver. Refer to
LED Indicators (page 7)
for more information.
2
FW
Connect a mini USB-to-USB cable from this port, to a computer, to update the firmware.
Refer to
Updating the Firmware (page 10)
for more information.
3
DEVICE
Connect up to two USB 2.0 devices (e.g. mouse, keyboard, etc.) to these ports. Each port
provides 5 V / 500 mA.
4
HDBaseT IN
Connect a category cable from this port to the
HDBaseT OUT
port of the AT-OME-EX-TX.
The AT-OME-EX-TX is powered by the AT-OME-EX-RX over HDBaseT.
5
HDMI OUT
Connect an HDMI cable from this port to the display (sink) device.
6
LAN
Connect a category cable from this port to the display (sink) device. This cable provides IP
pass-through transport control to the display (sink) device, from a control system connected
to the transmitter.
7
RS-232 / IR
Connect the included 4-pin captive screw block to this receptacle. Refer to
RS-232 and IR
(page 4)
for more information.
8
DC 48V
Connect the included 48 V DC power supply to this power receptacle.
1
5
2
3
4
6
7
8
Front
Rear
AT-OME-EX-RX
