Atlona AT-UHD-CLSO-824, User Manual

Page: 22 / 33

22
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
1 2 3 4
5 6 7 8
1 2
Aux 1 Aux 2 Aux 1 Aux 2
AFV
Output
Duck
Duck
CLSO-R3
Power
Input
On
1 2 3 4
Route Recall
AFV AFOV
Off
AFOV
Mute Mute
Vol
Vol
Aux 1 Aux 2 Aux 1 Aux 2
AFV
Audio Out 1 Audio Out 2
Duck Duck
AFV AFOV AFOV
Remote
Power
On - takes CLSO-824 on
Off - sets CLSO-824 to standby
Output
1 - HDMI and HDBaseT output 1
2 - HDMI and HDBaseT output 2
Source Selection
1 - HDBaseT 1
2 - HDBaseT 2
3 - HDBaseT 3
4 - HDMI 4
5 - HDMI 5
6 - HDMI 6
7 - HDMI 7
8 - VGA 8
Route Recall
Recalls previously saved input/
output routes
Audio Out 1
AFV - Audio is de-embedded from
HDMI/HDBaseT output 1
AFOV - Audio is de-embedded
from HDMI/HDBaseT
output 2
Aux 1 - Select audio from
MIC/48V/Line input 1
Aux 2 - Select audio from
MIC/48V/Line input 2
Duck - Selects ducking mode for
AUX sources over selected
embedded audio. Toggles
to mix mode.
Mute - Silences all audio 1 outputs
Volume - Adjust volume
Audio Out 2
AFV - Audio is de-embeded from
HDMI/HDBaseT output 2
AFOV - Audio is de-embeded from
HDMI/HDBaseT output 1
Aux 1 - Select audio from
MIC/48V/Line input 1
Aux 2 - Select audio from
MIC/48V/Line input 2
Duck - Selects ducking mode for
AUX sources over selected
embedded audio. Toggles
to mix mode.
Mute - Silences all audio 2 outputs
Volume - Adjust volume
System IR is typically used to connect to control system processors. This input is used to control the
CLSO-824.
Note:
The IR receiver is optional for the UHD-CLSO-824. The compatible IR receiver (AT-IR-CS-RX) can be purchased
through atlona.com.
The wires of the emitter and receiver have been marked to differentiate the pin outs.
The included IR emitter has two wires: signal and ground. Signal will have a solid line and ground will be
blank. The IR emitter will plug into the IR OUT ports.
There are three wires on the IR receiver
(sold separately)
: signal, ground, and power. Signal has a dotted line,
ground will be blank, and power will have a solid line. The IR receiver will plug into the IR IN ports.
Signal (S)
Ground (
)
Signal (S)
Ground (
)
Power (P)