www.atlona.com | toll free:
1-877-536-3976
For International: 1-
408-962-0515
5
OPERATION CONTROLS
1. Display: displays setting information with each output and input selection.
2. IR sensor.
3. POWER: Press this button to turn the switcher ON. When switcher is ON the LED will illuminate
GREEN. Press it again to enter into STANDBY mode, the LED will illuminate in RED.
4. EDID: Press this button to select the EDID function from the Display. There will be two selections
available shown on the display:
1. TV Mode
and
2. Standard Mode
. Press the number key to select
the desired input first, then press 1 or 2 to select the EDID mode.
The LED will illuminate while setting the EDID. After the selection is made, press the enter key to
confirm the selection.
Standard mode
means the device will use the internal built-in EDID.
TV mode
means the device will use TV or Audio Receiver EDID. Factory default setting is on TV mode.
Notes:
1. When the EDID switch is set to TV, the device will detect the first HDMI output source’s EDID from A to D and
record in the unit regardless of the HDMI output source from E to H. If the first detected output source is DVI, it will pass
along to the next source, until the first HDMI is detected. The detection priority is HDMI v1.3 > HDMI v1.2 > DVI.
2. When the EDID is on STD, the device will use the built-in EDID Video Supports < 1080p 10 bits (max) Audio
Supports = PCM2
5. LOCK: Press this button to lock all functions on the front panel and press it again to release the lock
function. When the LED illuminate in GREED, lock function is activate. If the LED is not illuminate, the key lock
is released.
6. ENTER: Press this button after each and every selection to confirm the selection. If this button is not
pressed after 20 second of the selection, the selection will be void.
The following sections describe the hardware components of the unit.
7.1. Front Panel
