AT-ETU-SYNC
10
Installation
1.
Connect an HDMI cable from the source to the
HDMI IN
port on the AT-ETU-SYNC.
2. Connect an
HDMI cable from the sink (display) to the
HDMI OUT
port on the AT-ETU-SYNC.
3. Connect the included 5V DC power supply to the
FW / PWR
port on the AT-ETU-SYNC.
4.
Connect the 5V DC power supply to an available AC outlet.
Video
Video
AT-ETU-SYNC
HD/UHD Source
Display (Sink)
The illustration below, shows the proper location of the AT-ETU-SYNC in a basic source-sink setup. The location of
the AT-ETU-SYNC will vary, depending on the system. Before using the AT-ETU-SYNC as an EDID emulator, an EDID
must be selected or learned. Refer to
Selecting an EDID (page 11)
and
Learning an EDID (page 12)
for more
information.
Connection Diagram
IMPORTANT:
The AT-ETU-SYNC is a High Dynamic Range (HDR) device. For best performance,
use premium HDMI cables that are HDR-certified. The HDMI cable between the AT-ETU-SYNC and
the display (sink) and the should not exceed 15 feet (4.5 meters).
