F 36
Code
Description
Recommended Troubleshooting of Lockout
Codes
Note
213
Invalid Prepurge rate setting
L
214
Invalid Prepurge time setting
L
215
Invalid Purge rate proving setting
L
216
Invalid Run ame failure response setting
L
217
Invalid Run stabilization time setting
L
218
Invalid Stack limit enable setting
L
219
Invalid Stack limit response setting
L
220
Uncon gured Delta T limit setpoint setting
L
221
Uncon gured DHW high limit setpoint setting
L
222
Uncon gured Outlet high limit setpoint setting
L
223
Uncon gured Stack limit setpoint setting
L
224
Invalid DHW demand source setting
L
225
Invalid Flame threshold setting
L
226
Invalid Outlet high limit setpoint setting
L
227
Invalid DHW high limit setpoint setting
L
228
Invalid Stack limit setpoint setting
L
229
Invalid Modulation output setting
L
230
Invalid CH demand source setting
L
231
Invalid Delta T limit delay setting
L
232
Invalid Pressure sensor type setting
L
233
Invalid IAS closed response setting
L
234
Invalid Outlet high limit enable setting
L
235
Invalid Outlet connector type setting
L
236
Invalid Inlet connector type setting
L
237
Invalid DHW connector type setting
L
238
Invalid Stack connector type setting
L
239
Invalid Header connector type setting
L
240
Invalid Outdoor connector type setting
L
241
-255
RESERVED
Table F.1. Lockout and Hold Codes
F.2. C
ONTROLLER ALERT CODES
.
Code
Description
EE Management Faults
0
None (No alert)
1
Alert PCB was restored from factory defaults
2
Safety con guration parameters were restored from factory
defaults
3
Con guration parameters were restored from factory defaults
4
Invalid Factory Invisibility PCB was detected
5
Invalid Factory Range PCB was detected
6
Invalid range PCB record has been dropped
7
EEPROM lockout history was initialized
8
Switched application annunciation data blocks
9
Switched application con guration data blocks
10
Con guration was restored from factory defaults
11
Backup con guration settings was restored from active con-
guration
12
Annunciation con guration was restored from factory defaults
13
Annunciation con guration was restored from backup
Code
Description
14
Safety group veri cation table was restored from factory
defaults
15
Safety group veri cation table was updated
16
Invalid Parameter PCB was detected
17
Invalid Range PCB was detected
System Parameter Errors
18
Alarm silence time exceeded maximum
19
Invalid safety group veri cation table was detected
20-26
RESERVED
27
Safety processor was reset
28
Application processor was reset
29
Burner switch was turned OFF
30
Burner switch was turned ON
31
Program Module (PM) was inserted into socket
32
Program Module (PM) was removed from socket
33
Alert PCB was con gured
Summary of Contents for Triton T-80
