©2022
Atlas Sound LP
. T
he
Atlas
“Circle
A”
, Soundolier
, and
Atlas Sound are trademarks of
Atlas Sound L.P
. IED is a R
egistered
Trademark of Inno
vativ
e Electronic Designs LLC.
All rights reser
ved.
All other
Trademarks are propert
y of their respectiv
e o
wners. No endorsement is implied. Due to continual product de
velopment, specifications are subject to c
hange without notice.
ATS0
06960 R
evC 6/22
AtlasIED.com
TELEPHONE: (800) 876-3333
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
8. If you will be using the secondary speaker amplifier output, route the speaker cable through the top cover and connect to the Speaker Out
terminals, paying attention to the wiring polarity. Add extra cable length for a service loop during assembly.
Note:
There will be no audio present at
these secondary speaker terminals until the amp is configured from Single channel mode to Dual channel mode.
9. Position the top cover over the side cover screws and rotate the cover clockwise to align the top cover mounting screw holes. Install the 3
mounting screws which are located in the hardware bag. Then tighten the side cover screws.
10. Slide the top hole-plug over the main support cable, safety cable, and Ethernet cable using the opening on the side of the plug. Then slide the plug
down the cable and into the top cover hole. (Figures 7 and 8)
Note:
If the speaker is being installed outdoors, seal plug with RTV silicone to prevent moisture from entering speaker.
421.13
16.58
316.59
12.46
A
A
SECTION A-A
Figure 2
421.13
16.58
316.59
12.46
A
A
SECTION A-A
Figure 1
Top Cover Mounting Screws (3)
Top Cover Side Screws (2)
Figure 3
