Atlas Copco SK 160 SA 1, Instruction Manual

Page: 21 / 94

- 21 -
To release the lighting tower from the towing vehicle,
carefully follow the procedure below:
1. Engage the hand brake (1).
2. Disconnect the cable plug for the trailer lights (2).
3. Disconnect the safety wire from the towing
vehicle (3).
4. Uncouple the trailer from the towing vehicle by
releasing the locking lever of the tow-bar coupler
(4).
5. Proceed with positioning to set up the lighting
tower.
To reconnect the lighting tower to the towing vehicle,
proceed as above but in the reverse order (see
“Towing” on page 23).
3.2.2 Positioning the lighting tower
Follow the steps below to position the lighting tower:
1. Ensure that the hand brake (1) is engaged. The
end-of-drive sensor underneath the hand brake
must be fully pressed.
2. While firmly holding the supporting foot (5) of the
lighting tower with one hand, release the rotating
locking pin (8) and rotate the supporting foot
through 90°.
3. Once the supporting foot (5) has been rotated,
reposition the rotating locking pin (8), making
sure that it locks the foot perpendicularly to the
bearing surface (7).
4. Release the locking pin of the stabilizer (6) by
lifting it up and pull the foot into its initial position
(7) at the maximum extension of the stabilizer (9).
5. Once the stabilizer has been extended, release the
locking pin (6) to lock the stabilizer in position.
1
2 3 4
5 6
90°
9 8
7