ETV STB34-15-10-B
Safety Information
© Atlas Copco Industrial Technique AB - 9834 4846 00
5
well below the applicable threshold limit. Please consider lo-
cal requirements on the disposal of lead at product end of
life.
Regional Requirements
WARNING
This product can expose you to chemicals including
lead, which is known to the State of California to cause
cancer and birth defects or other reproductive harm. For
more information go to
https://www.p65warnings.ca.gov/
UK DECLARATION OF CONFORMITY
We,
Atlas Copco Industrial Technique AB
,
SE-105 23 STOCKHOLM SWEDEN, declare
under our sole responsibility that the product
(with name, type and serial number, see front
page) is in conformity with the following UK
Regulation(s):
S.I. 2008/1597, S.I. 2012/3032, S.I. 2017/1206
Designated Standards applied:
EN 300 328 V2.2.2, EN 301 489-1 V2.1.1, EN
301 489-17 V3.1.1, EN 55014-1:2017, EN
55014-2:2015, EN 61000-6-2:2019, EN
61000-6-4:2007+A1:2011, EN 62479:2010, EN
62841-1:2015, EN 62841-2-2:2014 + AC:2015
Authorities can request relevant technical information from:
Product Compliance Manager, Atlas Copco Industrial Tech-
nique AB, SE-105 23 Stockholm Sweden
Stockholm, 1 December 2021
Carl von Schantz, Managing Director
Signature of issuer
Authorized Representative UK:
Atlas Copco Ltd
Swallowdale Lane
Hemel Hempstead, Hertfordshire HP2 7EA
Safety
DO NOT DISCARD - GIVE TO USER
WARNING Read all safety warnings, instructions, il-
lustrations and specifications provided with this
product.
Failure to follow all instructions listed below may result
in electric shock, fire, property damage and/or serious
injury.
Save all warnings and instructions for future refer-
ence.
WARNING All locally legislated safety rules regard-
ing installation, operation and maintenance shall be
respected at all times.
Statement of Use
• For professional use only.
• This product and its accessories must not be modified in
any way.
• Do not use this product if it has been damaged.
• If the product data or hazard warning signs on the prod-
uct cease to be legible or become detached, replace with-
out delay.
• The product must only be installed, operated and ser-
viced by qualified personnel in an industrial environ-
ment.
Intended Use
This product is designed for installing and removing threaded
fasteners in wood, metal or plastic. Indoor use only.
No other use permitted.
Product Specific Instructions
General Installation Safety
Refer installation to qualified personnel only.
Hang the tool securely, by for example using a balancer.
When using a suspension yoke, check that it is in good con-
dition and correctly fastened.
Dual Trigger
Dual trigger (Recommended to use during
operation)
WARNING Crushing Hazard
The Dual trigger forces the user to use both hands to op-
erate the tool. If not used, the operator can accidentally
start the tool while adjusting the crowfoot, thus resulting
in a serious hand injury.
►
Make sure the tool cannot be started once the Dual
trigger has been released.
►
Always test the tool by first releasing the trigger of
the Dual trigger, then push the trigger of the tool. If
the tool starts; stop working.
General Operation Safety
•
Due to entanglement risk, do not wear gloves.
•
Be prepared of the reaction force which will occur
when the tool is used.
Always support the tool’s handle
securely in the direction opposite to the spindle rotation,
in order to reduce the effect of sudden torque reaction
during final tightening and initial loosening.
•
Never hold the drive, socket or drive extension.
