Operation
EN
LSV39 SA12-125
12
© Atlas Copco Industrial Technique AB - 9839 0621 01
1
Nut/washer
3
Nut locking the wheel/brush/pad
2
Wheel/Brush/Pad
4
Locking kit
Adjusting the wheel guard
DANGER Risk of Injury
There is a risk of injury if the tool is used without the wheel guard.
►
Always use the tool with the recommended wheel guard.
►
Make sure that the wheel guard is positioned correctly and not damaged.
WARNING Risk of injury
►
Always shut off air supply, drain hose of air pressure and disconnect tool from air supply when not
in use, before changing accessories or when making repairs.
►
Always wear protective gloves when changing accessories or when making repairs.
Instructions
1.
Pull and hold the wheel guard lock button.
2.
Turn the wheel guard in a suitable position. Position the wheel guard between yourself and the grind-
ing wheel.
WARNING Risk of injury
■
Make sure that the wheel guard is put in a suitable position before operating the tool.
3.
Release the wheel guard lock button and make sure that the wheel guard is safely attached.
Fitting of support handle
WARNING Risk of injury
►
Always shut off air supply, drain hose of air pressure and disconnect tool from air supply when not
in use, before changing accessories or when making repairs.
►
Always wear protective gloves when changing accessories or when making repairs.
The support handle can be attached to any side of the tool.
1.
Remove the support handle by turning it counterclockwise.
2.
Attach the support handle to the opposite side.
Tighten the handle clockwise to the recommended torque.
