Atlantis NetFly AP4 WN, Manual

Page: 65 / 90

65
your wireless network name is broadcast to anyone within the range of
your signal. If you're not using encryption then they could connect to
your network. When this is disabled, you must enter the Wireless
Network Name (SSID) on the client manually to connect to the network.

WMM : Choose to Enable or Disable WMM. This is the Quality of
Service (QoS) feature for prioritizing voice and video applications. This
option can be further configured in WMM under the Wireless drop-
down menu.

Encryption : Select WEP from the drop-down list.

Authentication Type: Select Open System , Shared Key, or auto .
Authentication method from the drop-down list. An open system allows
any client to authenticate as long as it conforms to any MAC address
filter policies that may have been set. All authentication packets are
transmitted without encryption. Shared Key sends an unencrypted
challenge text string to any device attempting to communicate with the
AP. The device requesting authentication encrypts the challenge text
and sends it back to the access point. If the challenge text is encrypted
correctly, the access point allows the requesting device to authenticate.
It is recommended to select Auto if you are not sure which
authentication type is used.

Key Length : Select a 64-bit or 128-bit WEP key length from the
drop-down list.

Key Type : Select a key type from the drop-down list. 128-bit encryption
requires a longer key than 64-bit encryption. Keys are defined by
entering in a string in HEX (hexadecimal - using characters 0-9, A-F) or
ASCII (American Standard Code for Information Interchange -
alphanumeric characters) format. ASCII format is provided so you can
enter a string that is easier to remember.

Default Key : You may choose one of your 4 different WEP keys from
below.

Encryption Key 1-4: You may enter four different WEP keys.

Enable 802.1x Authentication : Place a check in this box if you would
like to use RADIUS authentication. This option works with a RADIUS
Server to authenticate wireless clients. Wireless clients should have
established the necessary credentials before attempting to authenticate
to the Server through this Gateway. Furthermore, it may be necessary to
configure the RADIUS Server to allow this Gateway to authenticate
users. You will then be required to specify the RADIUS Server‟s IP
address, port, and password.

Click on the Apply button to save the changes.