ENG
16
Copyright Statement
No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by
any means, whether electronic, mechanical, photocopying, recording or otherwise without the prior writing
of the publisher. Windows™ 98SE/2000/ME/XP/VISTA are trademarks of Microsoft
®
Corp. Pentium is
trademark of Intel. All copyright reserved.The Atlantis logo is a registered trademark of Atlantis. All other
names mentioned mat be trademarks or registered trademarks of their respective owners. Subject to change
without notice. No liability for technical errors and/or omissions.
CE/EMC Restriction of Liability
The product described in this handbook was designed, produced and approved according to the EMC-
regulations and is certified to be within EMC limitations. If the product is used in an uncertified PC, the
manufacturer undertakes no warranty in respect to the EMC limits. The described product in this handbook
was constructed, produced and certified so that the measured values are within EMC limitations. In practice
and under special circumstances, it may be possible, that the product may be outside of the given limits if it
is used in a PC that is not produced under EMC certification. It is also possible in certain cases and under
special circumstances, which the given EMC peak values will become out of tolerance. In these cases, the
user himself is responsible for compliance with the EMC limits.
In a domestic environment, this product may cause radio interference, in which case the user may be required
to take adequate measures.
Declaration of Conformity (
)
Product complies with 2014/30/CE (ex 2004/108/CE) Directive. The declaration in full version and the technical
documentations are available at our headquarters. Keep the packaging for future references. CE and WEEE
logo should be not fully compliant with minimum dimensions requirement to European Directive due to limited
area.
Cautions in installation
Do not install the camera in extreme temperature conditions. Do use the camera under conditions where
temperatures are within -15
℃
~+40
℃
.
Do not install the camera under unstable lighting conditions. Severe lighting change or flicker can cause the
camera to work improperly.
Do not install or use the camera in an environment where the humidity is high (85%RH maximum). It can
result in poor-quality image.
Do not disassemble the camera. There are no user serviceable parts inside it. Opening or removing the
camera
’
s cover may expose you to dangerous voltage or other hazards. Refer all servicing to qualified
personnel only.
Do not touch the imaging surface of sensor. Use a soft cloth with alcohol to clean the surface if it is touched
accidentally.
Ensure the supply voltage is correct before operation. Camera must be connected to a surge protector at
all times.
Do not focus the camera on the sun directly.
Handle this camera with care Avoid any shock or bumping of the camera. Improper handling could damage
the camera.
Clean the front face to the pick-up device. It is recommended that the pick-up device surface be cleaned
before lens installation or whenever the lens is changed. Cleaning should be done by using a chamois, a
very fine soft cloth, lens tissue, or cotton tipped applicator and ethanol to carefully remove any fingerprint
or dust.
Objects and liquid entry Never push objects of any kind into this camera as this may touch dangerous
voltage points of short out parts that could result in a fire or electric shock. Never spill any kind of liquid on
the video product.
Damage requiring service unplugs this video product from the wall outlet and refers service to qualified
servicing personnel under the following conditions:
Summary of Contents for NetCamera 510A-D
Page 1: ......
Page 27: ...APPENDIX 27 ...
