16
2.3 Setup dell’UPS
Step 1: Collegamento dell’UPS alla rete elettrica
Connettere il cavo schuko fornito all’UPS (Pannello posterione, Indentificativo N°3)
e alla rete elettrica (verificare che questa abbia una corretta messa a terra). Non
utilizzare mai cavi di estensione o prolunghe.
Step 2: Collegamento del carico all’UPS
Nella parte posteriore dell’UPS sono presenti diverse prese IEC320, in numero
variabile secondo il modello. Alcune di queste sono programmabili (si spengono
dopo un tempo impostato, per permettere di salvare l’energia residua delle batterie
per i carichi critici) mentre altre sono sempre attive (l’UPS fornirà tensione in
modalità batteria sino all’esaurimento di queste).
Fatte queste considerazioni è opportuno collegare i carichi, a seconda della loro
criticità, alle prese opportune.
Step 3: Porte di Communicazione
L’UPS integra 2 porte di comunicazione locali (USB/RS232) ed uno slot in cui
inserire la scheda SNMP opzionale.
USB Port
RS232 Port
Intelligent Slot
Tramite il software di gestione (scaricabile all’indirizzo
www.atlantis-land.com
) è
possible controllare lo stato di funzionamento dell’UPS e permettere lo spegnimento
controllato del PC collegato tramite RS232/USB.
La scheda SNMP opzionale permette inoltre di gestire l’UPS tramite LAN (anche da
postazioni remote) e permette lo spegnimento di diversi PC in LAN (con il rispettivo
client installato).