14
TROUBLESHOOTING TIPS
Water dispenser
or dispensing tap
is leaking
Small pin hole or crack in the bottle,
(common with recycled water
bottles).
Drain cap and silicone seal are
not secure.
Water was poured directly into bottle
support funnel and overflowed.
Water is not hot or
cold enough
All the water in the tank has been
used.
The unit is unplugged.
The circuit breaker in your home is
tripped or the fuse has blown.
Power switch not turned ON at
back of unit.
Temperature manual thermostat
tripped.
Water dispenser
is not dispensing
water
Empty water bottle.
Possible ice build up due to
thermostat set too cold.
Water dispenser
is noisy
Bottle making a gurgling noise as it
fills the tank.
Conduct water bottle leak test
as outlined in manual.
Ensure seal is secure in drain
plug an
d
tighten drain cap.
Drain by pressing dispenser buttons.
Replace with full bottle and wait 30
minutes for the water to heat or cool.
Plug it into the outlet.
Reset the breaker or replace the fuse.
Turn switch to the ON position.
Rotate
knob using screwdriver
clockwise to increase cooling and
anti clockwise decrease cooling.
Replace with full bottle.
Make sure the dispenser is on an even
surface that can support its full weight.
Unplug overnight, then reset. Reduce
thermostat setting.
Hot water
Cold water
Thermostat needs to be adjusted
for colder water.
Press the reset button on manual
thermostat.
This is normal.
Water dispenser is uneven.
POSSIBLE CAUSE
PROBLEM
SUGGESTED SOLUTION
15
TROUBLESHOOTING TIPS AIRPRESS
How much
Mode
Airpress
come with
Atlantis Airpress come with ON/OFF
mode
(By Default) with
blue LED
continuously
glowing, where show finger to START and
show finger to STOP. Second one is
steady
mode
where show finger to START otherwise
STOP.
How Can We Change the
Mode
For switching
ON/OFF mode
to
steady mode,
Air-press the hot water and cold water for
10 seconds and Hot water and cold water LED
blinks for 5 seconds. Repeat the same process
switching
steady mode
to
ON/OFF mode
.
What is
Child Lock
In
child lock
, dispense hot water by Air-press
hot water two times within 2 seconds and red
LED blinks continuously.
How to activate
Child
Lock
By default
child lock
is inactive, to activate
child lock
, Air-press the hot water and normal
water together for 10 seconds and hot and
normal LED blinks for 5 Seconds.
Why water dispense OFF
automatically
By default 6 seconds dispense timing is activate
and OFF after 6 sec. But setting can be change
to 3 seconds.
How can change
dispense setting 6
second to 3 second
To activate 3 second setting, Air-press thecold
water and normal water together for 10 seconds
and cold and normal LED blinks for 5 seconds.
PROBLEM/FEATURE
DESCRIPTION
Important:
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
