To remove, take the grill off the tray and firmly li the tray up, dislodging
it from the guides. Drain and clean.
The waste water tray should be emptied and
cleaned regularly to remove spotting and any
mineral deposits. Clean with water dispenser
cleaning solution or a mild soap and water.
For tough deposits, add vinegar and let it soak
until the deposits come loose. Then wash, rinse
and dry thoroughly.
To replace, put the grill back on the tray and
slide the tray onto the guides.
The outside of the dispenser can be wiped clean with water dispenser
cleaning solution or a mild soap and water. Never use harsh chemicals or
abrasive cleaners. Rinse thoroughly with clean water and then dry surfaces.
CLEANING THE OUTSIDE OF THE WATER DISPENSER
CLEANING THE WASTE WATER TRAY
CLEANING AND MAINTENANCE
Like most appliances, your new water dispenser requires periodic maintenance
to operate efficiently. Your water dispenser must be cleaned every 4 months.
Please note that as per your warranty, routine maintenance of the dispenser
is required. Failure to maintain the water dispenser will void your warranty.
IMPORTANT:
Make sure you turn the power switch to the OFF position and
unplug the dispenser before performing any of the following cleaning
procedures.
CLEANING YOUR WATER DISPENSER
9
CHILDPROOF SAFETY FEATURE - IN HOT & COLD MODEL ONLY
To prevent hot water from accidentally harming a child, the hot water
dispenser button has a safety switch on it. Available in some models only.
DANGER:
The hot water is heated to approximately 194˚ F / 90˚ C.
Temperatures above 125˚ F / 52˚ C can cause severe burns from scalding.
DO NOT ALLOW CHILDREN TO USE THE HOT WATER DISPENSING
BUTTON WITHOUT PROPER AND DIRECT SUPERVISION.
ADJUSTING THE TEMPERATURE (COLD WATER ONLY)
By turning the thermostat at the back of the unit, the
temperature can be adjusted. If the water dispenser is
not dispensing water, there could be a possible ice build
up due to the thermostat being set too cold. If this
happens, unplug the dispenser overnight and then reset
the thermostat. The thermostat knob is behind the OK
tested sticker at the back of the machine. Remove the
sticker and turn the knob clockwise to make the water
colder and anti clockwise to make it warmer.
O
Please note that the cold water thermostat has been factory adjusted to 11 C.
Avoid adjusting the thermostat unless required.
OK
TESTED
R
E
M
R
A
W
Reset Thermostat
HOT WATER TEMPERATURE – IN HOT & COLD MODELS ONLY
The temperature of the hot water in the dispenser maintained
by a preset automatic thermostat set at 85 °C and cannot be
adjusted manually by user.
There is also a manual reset safety thermostat set at 95 °C.
If there is no water in the hot tank and the hot water switch is
turned on by mistake, the manual safety button on the safety
thermostat will trip. In such an event, the reset button needs to
be preset as shown in picture (lower one on the tank) needs
to be pressed as shown in the picture.
8
CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out,
this appliance must not be supplied through an external switching device, such as a
timer or connected to a circuit that is regularly switched on and off by the utility
