WebShare 340/440
44
checks these different filter rules one by one, stating from the first rule. As long as one of the
rules is satisfied, the specified action will be taken.
•
Add TCP/UDP Filter:
Click this button to add a new packet filter rule. After click, next
figure will appear.
•
Add Raw IP Filter:
Click this button to add a new Protocol Filter.
•
Packet Filter Rules:
On this table, you see packet filter rules; you can click on
Edit
to
modify rule or
Delete
•
Rule Name:
Insert rule name; rule name must be different
•
Time Schedule:
It is self-defined time period. You may specify a time schedule for
your prioritization policy. For setup and detail, refer to
Time Schedule
section
•
Source IP Address(es) / Destination IP Address(es):
This is the Address-Filter
used to allow or block traffic to/from particular IP address(es). Selecting the
Subnet
Mask
of the IP address range you wish to allow/block the traffic to or form; set IP
address and Subnet Mask to
0.0.0.0
to inactive the Address-Filter rule.
•
Type:
Specify the packet type (UDP or TCP) that the rule will be applied to.
•
Source Port:
This Port or Port Ranges defines the port allowed to be used by the
Remote/WAN to connect to the application. Default is set from range
0 ~ 65535.
It is
recommended that this option be configured by an advanced user.
•
Destiantion Port:
This is the Port or Port Ranges that defines the application.
•
Inbound / Outbound:
Select
Allow
or
Block
the access to the Internet
(
“Outbound”
) or from the Internet (
“Inbound”
).
Summary of Contents for A02-RA340
