Instruction Manual
7
the negative (-) leads to the black terminals. Look carefully at the wires you are using and
note that one of the conductors of each pair will typically be identifi ed by color print-
ing on the outer jacket, ridges on the outer jacket, or a thread intertwined with the wire
strands. By convention, the marked wire is connected to the red (+) terminal. Also be
sure that no stray strands of wire touch across any terminals.
WARNING: To prevent risk of electrical shock or damage to your equipment, always
switch off the amplifi er or receiver when making any system connections.
POWER SUPPLY:
A separate power supply and power supply cable have been
included with your system. After the audio connections have been made, connect the
cable from the power supply to the DC IN jack on the rear of the speaker base. Then
connect the power supply cable to the power supply and plug it into an active outlet.
NOTE:
The power supply provided is capable of operating from 100-240 volts 50-60Hz.
WARNING: Before turning on the A/V receiver, be certain that no stray wire strands are
touching across any terminals as this might damage it.
Finally, recheck the polarity of your front speakers by listening to some music with
good bass content. If the sound seems “hollow”, unusually spread out, or seem to
have weak bass, reinspect your connections for proper polarity and correct any out of
phase connections.
all rights reserved. Designed in USA. Made in CHINA.
U.S. Patent 8,094,855 B2. H-PAS is a trademark of AT Int’l Corp,
Tested to Comply with FCC Standards for Home or Office Use.
RIGHT
CENTER
LEFT
LEFT
SURROUND
RIGHT
SURROUND
SUB OUT
optional surround speakers
POWER SUPPLY
A/V RECEIVER
(not included)
contact Atlantic Technology for recommondations
SYSTEM WIRING DIAGRAM
