3.1 HSB Speaker Base System with H-PAS
6 Connecting Your System
all rights reserved. Designed in USA. Made in CHINA.
U.S. Patent 8,094,855 B2. H-PAS is a trademark of AT Int’l Corp,
Tested to Comply with FCC Standards for Home or Office Use.
1
2
3
4
5
6
7
8
1. Standby/Status: Controls and indicates the
power and auto sensing circuit
2. DC IN: Input connector for power supply
3. Lowpass Control: Controls the internal low pass
fi lter
4. Bypass switch: Activates the Lowpass control
5. Phase switch: Controls the phase of the subwoofer
6. Level control: Controls the subwoofer output level.
(volume control)
7. Input: Subwoofer input (RCA connector)
8. Front Left, Center, Right Speaker Inputs
Connecting Your System
Follow the SYSTEM WIRING DIAGRAM to connect the 3.1HSB to your system.
SUBWOOFER
: Use a quality RCA cable to connect from the SUB output on your A/V
receiver to the subwoofer INPUT (7) on the back of the 3.1 HSB.
FRONT CHANNEL SPEAKERS
: Using high quality dual conductor stranded wire of
16 gauge or heavier, connect the speaker wires from the output terminals on the A/V
Receiver to the appropriate speaker input terminals on the back of the 3.1 HSB. The
lower the gauge number, the heavier the wire. Use heavier gauge wire for runs over 25'
(7.62m).
Remove ½ inch (6mm) of insulation from the end of each wire. Push down on the ter-
minal connector and an opening will appear in the connector that is capable of hold-
ing heavy gauge wire. Insert the bare wire into the opening and release the terminal. Be
sure to observe correct polarity, connecting the positive (+) leads to the red terminals and
Rear View
