Atlanta ATH-946, Instruction Manual

Page: 7 / 24

7
INSTRUCTION MANUAL
part and the whisker storeroom with water each time after using it.
Do be careful when using hot water. Do remember to check the water is not too hot
to avoid doing harm to hands.
1. Stop the shaver.
2. Pull away the four shaver heads on the side one by one and then rotate and pull
out the middle head in the arrow direction indicated on it .
3. Clean the two shaver head part and the hair storeroom for some time with hot
running water.
Make sure the inside of both the shaver head part and the hair storeroom has been
cleaned thoroughly.
4. Wash the product's surface.
5. Close the shaver head part and throw off surplus water.
Do not wipe the shaver head part with a towel or paper tissues, which may cause
damages to the shaver head.
6. Open the shaver head part again and remain so to dry up the product.
You can also use the brush included to clean the hair storeroom. Here water should
not be used.
Change and clean head assembly
1. Open the shaver head part, then pull out the shaver and unload the fixed mount .
2. Clean the blade and the foil with the brush included . Do not dean both of blade
and foil at the same time because they are integrated. If the blade and the foil are
matched improperly due to carelessness, if II take a couple of weeks for the product
to return to the best shaving performance.
3. Load new or cleaned shaver heads and then the fixed mount back to the shaver
head part.
Make sure the dent on the edge of the shaver head part (foil cover) matches the
bulge of the floating ring correspondingly and the bulge of the shaver head Is just
inserted into the dent on the center of the foil cover.
4. Reload the shaver head part on the shaver and then close it.