Technical Manual & Parts Lists
21
1347D Sewing Head Parameter List
PARAMETER
RANGE
SUGGESTED/
VALUE
SHIPPED/
VALUE
11347D PARAMETER DESCRIPTION (SEWING HEADS)
Do this first
*****
****
Perform a master reset before programming, see below
290
5
Mode (Chainstitch) of operation. MUST SET THIS PARAMETER
FIRST!
026
0-5
0
F-026=0 to disable the EB401 selection after power on.
111
200-9900 rpm
350
Maximum speed when "129" is 0, 1, or 2.
119
1-3
1
Linear Acceleration
161
0-1
1=CCW
Motor Rotation
240
0-31
6
Machine run blockage with open contact
270
0-5
1
External Hand Wheel Sensor Configuration.
272
020-255
90
Drive ratio between motor pulley and handwheel pulley. If handwheel
pulley is smaller than motor pulley, increase this value to slow down
sewing head until measured speed matches speed set with
parameter 111. (For Yamato and Pegasus, setting should be 100; for
Rimoldi, setting should be 124)
436
0
0
Use code "5913". This disables an input that was causing box to
reset itself.
Front panel LED's:
Programming Instructions:
LED 1: Off
1. Power on holding down the "P" button till "COD" is displayed.
LED 2: Off
2. Press ">>" once and enter the number "311"
LED 3: Off
3. Press "E" once and "2.0.0." is displayed this is a parameter
LED 4: Off
4. Proceed to the parameter to be changed and press "E".
LED 5: Off
5. The value now shows in the screen, adjust to desired value.
LED 6: Off.
6. Press "E" to enter value and continue with parameter setting.
LED 7: OFF, Stop at needle down.
7. Repeat for other parameters, press "P" once when complete.
LED 8: ON, Stop at needle up
8. Run sewing head to save parameters before powering down
To Perform Master Reset of Parameters:
1. Power on holding down the "P" button till "COD" is displayed.
2. Press ">>" once and enter the number "591"
3. Press "E" twice and "093" is displayed.
4. Press "+" once, "094" is displayed.
5. Press "P" to exit programming mode with all default values.
Summary of Contents for 1347D
