Atlanta 1337DL, Technical Manual & Parts Lists, Page: 30 / 62

Technical Manual & Parts Lists
25
7) The display will change to “0.4.0.0.” this is a parameter
number “400”. Number with the “.” between the digits are
parameters.
To move to the correct parameter you will press either the “+” or
“
‐
” buttons. Press and hold the “+” button, the parameter
numbers will start scrolling faster the longer the button is held
down, until “2.9.0.” is displayed. This is the first parameter to be
programmed when starting new, only using as an example. (You
may need to access a different parameter number, use the same
method as above)
8 ) With “2.9.0.”(or parameter number you chose) in the display,
which is parameter “290”, press the “E” button once to ENTER
the Parameter Number .
9) The display will change from “2.9.0.” to “05” (your display
may not be the same, depends on the type of sewing head being
used, refer to your machines programming sheet in manual) this
is the setting of parameter “2.9.0.” all displayed numbers without
the “.”are values of parameters. To change this number use the
“+” or “
‐
” button. Then press the “E” button once.