Atlanta Attachment Company 4300A, Technical Manual & Parts Lists

Page: 53 / 132

Technical Manual & Parts Lists
46
Eye Sensor Adjustment
1. Remove the clear plastic cover from the end of the sensor.
There are two adjusting screws under the cover. One is
labeled “GAIN” and is used to set the sensitivity of the
sensor. The other screw is labeled “DO & LO” and should
always be fully clockwise.
2. With the end of the sensor pointing at the center of the
reflective tape, turn the “GAIN” screw counter-clockwise
until the red LED indicator is off
3.
Then turn the “GAIN” screw clockwise until the LED
indicator comes on.
4.
Then turn the “GAIN” screw one full turn clockwise. The
LED indicator should be blinking slowly.
5. Cover the eye so that the sensor cannot see the reflective
tape and the LED should go off.
Reflective Tape Maintenance
Use a soft cloth for cleaning. Do not use chemicals or abrasives
to clean it. Avoid any contact with oils and liquids. Do not touch
the tape with bare fingers. If tape is dirty or opaque, the eye may
not function correctly.
2.- Flaw Mark Eye FFSE3WLC
There are 2 flaw mark sensor on the machine
NOTE: It is looking for a black mark indicating a flaw, which
has been previously marked during the prior process.
1.- For the detection of any flaw on the handles “A”
2.- For the detection of any flaw on the border. “B”
From
the
library
of:
Diamond
Needle
Corp