16
ATIM_ACW-D_UG_EN_V1.5
d.
Slave Modbus configuration (SF8 & 868)
Attention
For SF8 (Sigfox) versions, setup available for references Software 2.3 Revision B.0 or prior.
The following information applies to the ACW / SF8-DINRS, ACW / 868-DINRS and ACW / 868-DINRS +.
In this mode of operation, the ACW-DINRS is seen as a Modbus slave on the RS232 or RS485 serial link, as
well as by the radio.
Note :
Les trames Modbus ne doivent pas dépasser 512 octets.
✓
1: Serial parameters: The ACW-DINRS module has a serial link that you can set in RS232 or RS485
mode. You must also specify the speed (Baudrate) you want to use: 4800, 9600, 19200, 38400, 57600,
and 115200 are available. The other default and non-configurable parameters are: 1 stop bit, no
parity, no flow control and 8 data bits
