14
ATIM_ACW-TMxP_UG_EN_V1.0
c.
Test frame emission
When the product is in its operating mode (and only in this mode), it is possible to send a test frame (which avoids
waiting for the next measurement frame) including a measurement sample.
To do this, simply bring the magnet closer until the
GREEN
light signal goes out. The successful sending of the test
frame will be indicated by a
CYAN
light signal.
d.
Deep sleep setup
While transporting or storing the ACW-TMxP, it is best to place it in its deep sleep mode to limit unnecessary energy
consumption.
From any operating mode (except fault mode), bring a magnet near the diamond marking on the box for
6 seconds
.
During these six seconds, the LED of the product will flash in the color corresponding to the operating mode then the
end of the sequence will be indicated by a
WHITE
fade acknowledging that the product has been put on standby. The
magnet can therefore be removed.
e.
Radio module activity
Any sending of a radio frame is indicated by three brief
GREEN
flashes of the LED.
f.
Threshold exceeded
When thresholds have been configured using the configurator and the measurement values exceed these thresholds,
the product LED emits a periodic
ORANGE
flash to notify it.
g.
Anti-fraud system
A mechanism (push button) is present on the product to notify any opening of the case during normal operation.
Normally, the box exerts pressure on the button. As soon as the back cover is removed, the button is released,
triggering an alert. A light signal indicates that the opening of the case has been considered.
In addition, if the module is connected to a network, an alarm frame will be sent immediately when the box is opened
and then closed.
h.
Substitution to the magnet
You can use the push button on the ACW-TMxP card to perform the same actions as the magnet (activate or standby
the product, activate / deactivate Bluetooth).
To do this, open the box and press the push button twice at the same time. A white flash indicates that the button
now acts as the magnet (
button pressed = magnet approached
, refer to the chapters
and
above to know how to use the button).
WARNING: Once the operations are complete, press the button twice again to restore it to its main function. A
white flash indicates that the manipulation was successful.