ATIKA T 250 Eco-3, Original Instructions Manual

Page: 13 / 164

12

The machine may not be used in a potentially explosive
environment or be exposed to the rain.

Metal parts (nails, etc.) must be removed from the timber to
be sawn.
Residual risks
Even if used properly, residual risks can exist even if the
relevant safety regulations are complied with due to the design
determined by the intended purpose.
Residual risks can be minimised if the “Safety information” and
the “Intended usage” as well as the whole of the operating
instructions are observed.
Observing these instructions, and taking proper care, will
reduce the risk of personal injury or damage to the equipment.

Danger of injury of fingers and hands by the tool (saw
blade) or work piece, e.g. when replacing the saw blade.

Injury from parts of the workpiece spinning off.

Throwback of the workpiece or workpiece parts.

Breakage and expulsion of saw blade.

Risk from electricity, by using non-standard electrical
connections.
 Touching live parts of opened electrical components.
 Impairment of hearing when working on the machine for
longer periods of time without ear protection.
 Emission of harmful timber dust when operating without
exhaust suction.
In addition, in spite of all the precautionary measures taken,
non-obvious residual risks can still exist.
Safety instructions
Read all safety warnings and all instructions.
Failure to follow the warnings and instructions may
result in electric shock, fire and/or serious injury.
Be sure to observe the separately enclosed
"General safety notices for circular table
saws".
Save all warnings and instructions for future reference.
Description of device / spare parts
Pos.-
No.
Order-No. Denomination
2 366272 Supporting leg
3 366282
Connection strut – short

4 366280
Connection strut – long

5 366303 Saw blade
6  Crank for height adjustment
7 366504 Safety guard
8 366505 Splitting wedge
9 366261 Extraction hose
10  Bench plate
11 366254 Transverse stop cpl.
12 366255 Table insert
13 366506 Longitudinal stop cpl.
13A  Fence
14 366271 Adjusting knob for incline adjustment
15 366272 Clamping screw for incline
adjustment
16  On/Off switch
17  Motor protection
18 366270 Dust extraction port
19 366275 Sliding stick
22 366268 Saw blade flange
23 366269 Hexagonal screw for saw blade
24 366257 Guide section for longitudinal stop
25  Clamping lever for longitudinal stop
26 366288 Safety label
27 366282 Additional brace
28  Scale for cross-cut adjustment
29 366283 Slip-on foot
30
366273
Ring wrench size 10/21
31 Ring wrench size 10/13
Assembly
Please refer to the attached assembly and
operating instruction sheet.

Tighten all screw connections only hand-
tight first.
Place the saw with the table surface facing downwards
onto a suitable work surface.
Mount the table legs.  (2) to the device unit.
Secure the braces  (4) and  (3) to the table legs.

The braces have different lengths.
Secure the two long braces  (4) first to the table legs.
Now secure the two short braces

(3).
Mount the push-on bases (29) to the table legs.
Install the additional braces (27).

Firmly tighten all screw connections.
!