ATIKA T 250 Eco-3, Original Instructions Manual

Page: 17 / 164

16
Maintenance
Notes on saw blade change
Before replacing the saw blade:

switch off device

wait for stop of chain saw

pull out main plug

Do not use any saw blades made of HSS steel.
 Do not use any cracked saw blades or such that have
changed their shape.
 Only use well-sharpened saw blades.
 Use only suitable saw blades.
 Always use saw blades whose max. speed (see
identification on the saw blade) corresponds to the motor
speed indicated on the saw (see "Technical data").

Always use saw blades whose cutting width is greater and
whose main blade thickness is smaller than the riving knife
thickness.
Danger of burning! The saw blade is still hot shortly
after cutting. Allow the saw blade to cool down.
Danger of cutting! Wear gloves when replacing the
saw blade.
If possible, carry saw blades in a container.
Changing the saw blade:
Bring the saw blade to the highest position.
Remove the safety guard (7).
Remove the table insert (12).
Place the ring wrench (30) on the saw blade flange and
the ring wrench (31) on the hexagon screw. For loosening,
turn the ring wrench (31) in arrow direction.
Remove the hexagon screws (23) and the saw blade
flange (22). Pull the saw blade (5) off.
Clean the flange.

Fit the new saw blade in reverse order.
Firmly tighten the saw blade.
Note the direction in which the saw blade turns (see
arrow on saw blade).
Check the distance / Adjusting the riving knife:
Raise the saw blade (5) with the crank (6) to the highest
position.
Measure the distance between saw blade and blade guard
(8). The distance must be between 3 and 8 mm.
If required:
Loosen the screw (A) the adjust the distance.
Retighten the screw (A).
Finally, reinstall the table insert and the safety guard.
Replacing the table insert
A worn out or damaged table insert must be immediately
replaced.
Tool storage
Cleaning

Observe the following to maintain the functionality of the
saw.
 Do not wash down device with water.

Remove splints and sawdust only with a brush or vacuum
cleaner.
 Clean and oil all moving parts regularly.

Never use any grease!

Use for instance sewing machine oil, liquid hydraulic
fluid or environmentally acceptable spray oil.

Take care that the saw blade remains free of rust and resin.

Remove all resin residues from the saw bench top

Resin residues can be removed with a commercial
maintenance and care spray.

The saw blade is a wearing part and will become dull after
prolonged or frequent use.
renew the saw blade or have it sharpened
Transport
Remove mains plug before each transport.

The saw must only be transported with the saw blade
lowered and the protective cover in position.
This will avoid possible injury from the saw blade.
 Take hold on the right and left side of the saw for
transporting.
 If the saw is transported in a vehicle, it must be secured
against slipping and tilting. Avoid heavy vibration during
transport.

Never use the safety devices for handling and transport.
Storage
Remove the mains plug from the socket.

Store unused equipment in a dry, locked place out of the
reach of children.

To extend the service life of the saw and guarantee smooth
operation, before storing for a longer period

thoroughly clean the saw

treat all movable parts with an environmentally friendly
oil

Never use any grease !